Dalman Caution For Usage

Instructions for Use and Handling: Shake gently before use.
Before using the product, wash hands and remove dust cap.
Each spray has a dust cap which protects the nozzle and keeps it clean. Remember to take this off before using the spray.
Preparing the spray: A new spray (or one that has not been used for a few days), may not work first time. The patient needs to "prime" the spray by pumping the spray a few times until a fine mist is produced.
1. Hold the bottle and make sure it is pointed away from the patient.
2. Put forefinger and middle finger on the collar either side of the nozzle or put the thumb underneath the bottle.
3. Keep the thumb still, and press down with fingers to pump the spray.
If the spray does not work and the patient thinks it may be blocked, they will need to clean it. See the section as follows, Cleaning the spray.
Never try to unblock or enlarge the tiny spray hole with a pin or other sharp object. This will damage the way the spray works.
Using the spray: 1. Shake the bottle and take off the dust cap.
2. Blow nose gently.
3. Close one nostril with a finger, and put the nozzle in the other nostril. Tilt head forward slightly and keep the bottle upright.
4. Start to breathe in slowly through nose. While the patient is breathing in press down firmly on the collar with the fingers. A spray of fine mist will go into the nostril.
5. Breathe out through the mouth.
6. Repeat step 4 to use a second spray in the same nostril.
7. Remove the nozzle from this nostril and breathe out through the mouth.
8. Repeat steps 3 to 6 for the other nostril.
9. After using the spray, wipe the nozzle carefully with a clean tissue or handkerchief, and replace the dust cap.
Cleaning the spray: Clean the spray at least once a week, or more often if it gets blocked.
1. Take the dust cap off by gently squeezing the ribbed sides between a finger and thumb and lifting it off. Do not twist it off.
2. Pull upwards on the white collar to remove the nozzle.
3. Soak the nozzle and dust cap in warm water for a few minutes.
4. Then rinse under a running tap.
5. Shake off the excess water and let them dry in a warm place.
6. Put the nozzle back on the spray.
7. "Prime" the bottle, preparing the spray.