Momate Az Patient Counseling Information

Instructions for patient for using the Mometasone Furoate and Azelastine Hydrochloride Nasal Spray: 1. Remove the plastic cap.
2. Before you use Mometasone Furoate and Azelastine Hydrochloride Nasal Spray for the first time prime the pump by pressing downward on the shoulders of the white nasal applicator using your index finger and middle finger while holding the base of the bottle with your thumb. Do not pierce the nasal applicator. Press down and release the pump 10 times or until a fine spray appears. Do not spray into eyes. The pump is now ready to use. The pump may be stored unused for up to 1 week without repriming. If unused for more than 1 week, reprime by spraying 2 times or until a fine spray appears.
3. Gently blow your nose to clear the nostrils. Close 1 nostril. Tilt your head forward slightly, keep the bottle upright, carefully insert the nasal applicator into the other nostril. Do not spray directly onto the nasal septum (the wall between the two nostrils).
4. Then breath out through the mouth.
5. Repeat in the other nostril.
6. Wipe the nasal applicator with a clean tissue and replace the plastic cap.
Patient Instruction for Cleaning Applicator: 1. To clean the nasal applicator, remove the plastic cap.
2. Pull gently upward on the white nasal applicator to remove.
3. Soak the nozzle and dust cap in warm water for few minutes and then rinse thoroughly. Spray tip and dust cap in warm water and finally rinse under clean running water. Repeat the procedure if the mist is not coming out.
Note: In case during usage for the first time the actuator is observed to be blocked due to accidental pressing during transit or during handling which prompts release of miniscule contents, never use a pin or any sharp objects to pierce to unblock the nozzle instead subject the actuator for cleaning.
4. Put the nasal applicator back together making sure the pump stem is reinserted into the applicator's center hole.
5. Reprime the pump by pressing downward on the shoulders of the white nasal applicator using your index and middle fingers while holding the base of the bottle with your thumb. Press down and release the pump 2 times or until a fine spray appears. Do not spray into eyes. The pump is now ready to use. The pump may be stored unused for up to 1 week without repriming. If unused for more than 1 week, reprime by spraying 2 times or until a fine spray appears.
6. Replace the plastic cap.