FreeStyle Libre 2 Patient Counseling Information

Sensor: STEP 1: Select site.
STEP 2: Wash site using a plain soap, dry, and then clean with alcohol wipe. Allow site to air dry.
STEP 3: Peel lid completely off Sensor Pack.
Unscrew cap from Sensor Applicator.
CAUTION: Sensor codes must match on Sensor Pack and Sensor Applicator. Do NOT use if damaged or already opened.
STEP 4: Line up dark marks on Sensor Applicator and Sensor Pack. On a hard surface, press down firmly on Sensor Applicator until it comes to a stop.
STEP 5: Lift Sensor Applicator out of Sensor Pack.
STEP 6: Sensor Applicator is ready to apply Sensor.
CAUTION: Sensor Applicator now contains a needle. Do not touch inside Sensor Applicator or put it back into Sensor Pack.
STEP 7: Place Sensor Applicator over site. Push down firmly to apply Sensor.
CAUTION: Do NOT push down on Sensor Applicator until placed over prepared site to prevent unintended results or injury.
STEP 8: Gently pull Sensor Applicator away.
STEP 9: Make sure Sensor is secure. Discard the used Sensor Pack and Sensor Applicator.
See Disposal section in the User's Manual or under Cautions for Usage.