Phesgo Caution For Usage

Special precautions for disposal and other handling: Phesgo should be inspected visually to ensure there is no particulate matter or discolouration prior to the administration. If particulate matter or discoloration is observed the vial should be discarded per local disposal guidelines.
Do not shake the vial.
A syringe, a transfer needle and an injection needle are needed to withdraw Phesgo solution from the vial and inject it subcutaneously. Phesgo may be injected using hypodermic injection needles with gauges between 25G-27G and lengths between 3/8"(10 mm)-5/8"(16 mm). Phesgo is compatible with stainless steel, polypropylene, polycarbonate, polyethylene, polyurethane, polyvinyl chloride and fluorinated ethylene polypropylene.
As Phesgo does not contain any antimicrobial-preservative, from a microbiological point of view, the medicinal product should be used immediately. If not used immediately, preparation should take place in a controlled and validated aseptic conditions. After transfer of the solution to the syringe, it is recommended to replace the transfer needle by a syringe closing cap to avoid drying of the solution in the syringe and not compromise the quality of the medicinal product. Label the syringe with the peel-off sticker. The hypodermic injection needle must be attached to the syringe immediately prior to administration followed by volume adjustment to 15 mL if Phesgo 1200 mg/600 mg is used or 10 mL if Phesgo 600 mg/600 mg is used.
Phesgo is for single use only. Any unused medicinal product or waste material should be disposed of in accordance with local requirements.
Incompatibilities: Phesgo is a ready to use solution which should not be mixed or diluted with other products.